Apprentice answer

What should I check mechanically before the start-up tech powers on the RTU

4th YearDampers, Fire/Smoke & Life SafetyStop / Verify

Verify that all internal construction shipping tie-down braces are completely cut out from the fan motor frames. * Check that the drive belt alignment between the pulleys is straight and has the correct tension. * Verify that the manual system balancing dampers are locked wide open, all building fire dampers are set open, clean air filters are installed, and the internal fan wheel turns freely by hand without scraping the casing.

Ask a jobsite question Back to Dampers, Fire/Smoke & Life Safety

Plain-English answer

Field checklist

Verify that all internal construction shipping tie-down braces are completely cut out from the fan motor frames. * Check that the drive belt alignment between the pulleys is straight...

Ask Foreman

Hey boss, I’m on tab / startup prep and need verification before I touch this: What should I check mechanically before the start-up tech powers on the RTU? Do you want me to stop here and check the approved detail, submittal, or inspector/manufacturer requirement first?

Verify before acting

Use this as training guidance. The foreman, approved drawings, project specs, manufacturer installation instructions, employer safety policy, and AHJ/code requirements always control the final answer.

Related questions in this category

How do I verify that our shop-fabricated fire damper sleeves meet UL listing requirements?4th Year How do I ensure all VAV damper blades are in the open position before system blow-down?4th Year What documentation does the Fire Marshal need when inspecting smoke dampers?4th Year How do I troubleshoot a fire damper that won't drop during a drop test?4th Year How do I prepare the ductwork for a city inspector's rough-in inspection?4th Year How do I identify a 2-hour vs. a 1-hour fire wall on an architectural life-safety plan?4th Year