Not supporting flex at both ends

Support flex at both ends so neither collar carries the run weight.

Stop if

• This flex is not supported at both ends. Do you want supports added before ceiling close?

Watch out

• Do not let the collar or boot hold the weight of the flex run.

Check

• Check support near the duct collar.
• Check support near the boot/diffuser.
• Keep each end round and aligned.
• Add approved support near ends if needed.
• Recheck liner seal after support.

Steps

• Check support near the duct collar.
• Check support near the boot/diffuser.
• Keep each end round and aligned.
• Add approved support near ends if needed.
• Recheck liner seal after support.

More in Joints, TDC, Flanges & Connections