Flex lying on sharp metal edge
Move or protect flex lying on a sharp metal edge before it cuts the jacket or liner.
Stop if
- This flex is resting on a sharp edge. Do you want it rerouted or protected here?
Watch out
- Do not let flex rub on raw metal, threaded rod, deck, or framing edges.
Check
- Find the sharp edge/contact point.
- Lift/reroute flex off the edge.
- Add approved protection/support if directed.
- Inspect jacket/liner for cuts.
- Replace/repair if damaged.
Steps
- Find the sharp edge/contact point.
- Lift/reroute flex off the edge.
- Add approved protection/support if directed.
- Inspect jacket/liner for cuts.
- Replace/repair if damaged.
Say this to your foreman
This flex is resting on a sharp edge. Do you want it rerouted or protected here?
More in Joints, TDC, Flanges & Connections