TinnerFlow™1st YearHangers & SupportsYELLOW · Check First
1. Set up your rotating or cross-line laser at a known benchmark height or clear coordinate line. 2. Measure the exact offset from the laser line to your desired anchor point on the ceiling deck. 3. Mark out your anchor spacing along that laser projection line down the corridor to ensure the entire run hangs perfectly straight without snaking.
1. Set up your rotating or cross-line laser at a known benchmark height or clear coordinate line. 2. Measure the exact offset from the laser line to your desired anchor point on the ceiling deck. 3. Mark out your anchor spacing along that laser projection line down the corridor to ensure the entire run hangs perfectly straight without snaking.
Use this as training guidance. The foreman, approved drawings, project specs, manufacturer installation instructions, employer safety policy, and AHJ/code requirements always control the final answer.