TinnerFlow logoTinnerFlow™
Mistake & recovery · #096

Not converting properly between fractions and decimals when using a precision rule

3rd YearMeasuring & Layout

Keep a fraction-to-decimal conversion chart in your tool bag. For critical dimensions, cross-check your conversion with a calculator before scribing. One…

Search Field RescueAsk ForemanOpen in mistake guide

Safer field move

Keep a fraction-to-decimal conversion chart in your tool bag. For critical dimensions, cross-check your conversion with a calculator before scribing. One wrong conversion can ruin an entire fitting.

Ask Foreman

Can you verify this before I keep going? I’m looking at: Not converting properly between fractions and decimals when using a precision rule. What’s the approved correction for this job?

Do not

Do not hide, force, cover, or “make it work” if this affects safety, access, airflow, rated assemblies, supports, equipment, or inspection. Stop and verify the approved correction.

Related mistakes

#100 · Incorrectly reading isometric drawings and building fittings that are handed wrong3rd Year · Measuring & Layout#099 · Not adjusting layout for building out-of-square conditions3rd Year · Measuring & Layout#098 · Using a laser level that is out of calibration and not verifying with a bubble level3rd Year · Measuring & Layout#097 · Laying out a large duct bank without establishing a baseline control point first3rd Year · Measuring & Layout#008 · Measuring from the wrong reference point on the tape (the hook gap error)1st Year · Measuring & Layout

Related apprentice questions

#139 · How do I draft a field sketch so the fab shop makes exactly what I need?3rd Year · Field Math & Measuring#140 · How do I handle duct that arrives from the shop fabricated backwards?3rd Year · Field Math & Measuring#136 · How do I lay out a round lateral (wye) branch using a template?3rd Year · Field Math & Measuring#048 · How do I keep my cordless batteries from dying in cold weather?1st Year · Site Awareness