TinnerFlow logoTinnerFlow™
Mistake & recovery · #039

Leaving cut sheet metal scraps on the floor creating a slip and puncture hazard

1st YearCoordination & Professionalism

Sheet metal scraps go directly into the scrap bin — never on the floor. One scrap piece left underfoot can puncture a boot or send someone to the hospital.

Search Field RescueAsk ForemanOpen in mistake guide

Safer field move

Sheet metal scraps go directly into the scrap bin — never on the floor. One scrap piece left underfoot can puncture a boot or send someone to the hospital.

Ask Foreman

Can you verify this before I keep going? I’m looking at: Leaving cut sheet metal scraps on the floor creating a slip and puncture hazard. What’s the approved correction for this job?

Do not

Do not hide, force, cover, or “make it work” if this affects safety, access, airflow, rated assemblies, supports, equipment, or inspection. Stop and verify the approved correction.

Related mistakes

#038 · Failing to clean up your work area at the end of each shift1st Year · Coordination & Professionalism#037 · Not asking questions when unsure - guessing and installing something wrong1st Year · Coordination & Professionalism#036 · Showing up late repeatedly without communicating with the foreman1st Year · Coordination & Professionalism#040 · Not reading the shop drawing before beginning fabrication1st Year · Coordination & Professionalism#174 · Not documenting verbal owner requests in writing before performing extra work4th Year · Coordination & Professionalism

Related apprentice questions

#007 · When is it required to wear cut-resistant gloves when handling raw metal edges?1st Year · Hand Tools & Safety#096 · How do I safely drill out spot welds to modify a factory fitting?2nd Year · Field Mods#126 · How do we support vertical riser ductwork at each floor penetration?3rd Year · Sealing & Insulation#001 · What's the difference between red, green, and yellow aviation snips?1st Year · Hand Tools & Safety