What do I do when unistrut/trapeze cut sharp and left unprotected?
Hanger Systems, Rods, Straps, Trapeze & AnchorsPolished support starter — hanger/detail check
Treat supports as load-path work: unistrut/trapeze cut sharp and left unprotected.
Field checklist
- Check elevation
- Check rods are plumb
- Level the trapeze/support before final loading
Ask foreman
In Hanger Systems, Rods, Straps, Trapeze & Anchors, I’m looking at: What do I do when unistrut/trapeze cut sharp and left unprotected? What should I verify before I cut, drill, seal, cover, move, or install?
Do not
Do not use the duct to pull bad hangers into place.
Why it matters
Project drawings/specs, approved hanger/support detail, substrate/anchor requirements, foreman direction, and structural/coordination constraints.
Search words: hangers trapeze anchors sharp edge