Static field route #208

What do I do when not using correct hardware for brace assembly?

Seismic Bracing, Sway Control & Structural CoordinationHigh-risk starter answer — foreman/qualified-person verification required

Do not move seismic/sway bracing casually: not using correct hardware for brace assembly.

Open in Field Rescue Open category

Field checklist

Identify whether you are looking at a hanger, brace, restraint, anchor, insert, structural member, rigging gear, or crane/lift-day zone.
Verify the exact hardware, insert, clamp, anchor, washer, nut, and brace component from the approved detail/submittal.

Ask foreman

In Seismic Bracing, Sway Control & Structural Coordination, I’m looking at: What do I do when not using correct hardware for brace assembly? What should I verify before I cut, drill, seal, cover, move, or install?

Do not

Do not modify or copy bracing/rigging from another area just because it looks similar. Do not substitute lighter hardware or missing parts without foreman approval.

Why it matters

OSHA 1926.1425 keeping clear of load; OSHA 1926.1428 signal person qualifications; OSHA 1926.251 rigging equipment; SMACNA/project bracing details where applicable

Search words: seismic bracing structural hardware