Static field route #466

What do I do when not marking incomplete seal/insulation/hangers?

QA/QC, Punchlist, Documentation & TurnoverQA/QC starter — verify before calling it complete

Before calling a run complete, check the joints that people stop noticing: corners, backsides, seams, collars, taps, and hard-to-reach spots.

Open in Field Rescue Open category

Field checklist

Look at the top/backside of joints if accessible.
Check collars, taps, corners, flanges, and seams.
Confirm approved sealant/tape/mastic was used.
Look for skipped spots, gaps, or dirty surfaces.
Ask before sealing special/rated/grease conditions.

Ask foreman

Can you check this sealing before I call this run complete?

Do not

Do not assume a joint is sealed because the front face looks clean.

Why it matters

Leaks often hide on the side nobody looked at from the lift.

Search words: quality punchlist turnover status marking seal QA QC punchlist turnover documentation what do I do when not marking incomplete seal/insulation/hangers #466 seal QA QC punchlist turnover documentation what do I do when not marking incomplete seal/insulation/hangers #466 qaqc apprentice workflow