Static field route #676

What do I do when not checking hanger spacing after duct size changes?

Hanger Systems, Rods, Straps, Trapeze & AnchorsPolished support starter — hanger/detail check

Treat supports as load-path work: not checking hanger spacing after duct size changes.

Field checklist

Check support locations
Check heavy fittings/transitions
Confirm approved hanger detail

Ask foreman

In Hanger Systems, Rods, Straps, Trapeze & Anchors, I’m looking at: What do I do when not checking hanger spacing after duct size changes? What should I verify before I cut, drill, seal, cover, move, or install?

Do not

Do not guess hanger spacing when the run or duct size changes.

Why it matters

Project drawings/specs, approved hanger/support detail, substrate/anchor requirements, foreman direction, and structural/coordination constraints.

Search words: Hanger Systems, Rods, Straps, Trapeze & Anchors not checking hanger spacing after duct size changes