What do I do about screw penetrations near an S-and-drive joint?

Follow the project seal requirement. If screw penetrations need sealing, clean the area and seal with the approved material after the joint is mechanically correct.

Use screws only where the shop/project detail calls for them. Random screws can distort the joint or create more problems.

Rectangular Duct & Fittings 2nd Year YELLOW

Stop if

Ask when screw length/type/location or sealing requirement is unclear.

Watch out

Do not over-screw, strip, distort, or use screws to make up for a bad fit.

Check

Verify screw type/location if the detail requires it
Check for distortion, stripped holes, and seal path issues

Steps

Confirm whether the screw pattern is required.
Check if screws distorted the joint.
Clean around screw penetrations.
Seal with approved method if required.
Reinspect after sealant cures/sets as needed.

Say this to your foreman

In Rectangular Duct Assembly: S-and-Drive, I'm looking at: What do I do about screw penetrations near an S-and-drive joint? What should I verify before I cut, drill, seal, cover, move, or install?