What do I check for finish work: spin-in / tap final check near diffuser?
The tap near a final air device must be the right size, sealed, oriented correctly, and placed so the damper handle/access still makes sense.
Watch out
- Stop before cutting a main if the tap location, size, airflow direction, or damper access is not confirmed.
Check
- Check the hole size and tap fit before fastening.
- Keep the damper handle visible/reachable where required.
- Seal the joint cleanly per project specs.
- Avoid screw tips projecting into problem areas when avoidable.
- Check that flex/round connection can land without stress.
Steps
- Check the hole size and tap fit before fastening.
- Keep the damper handle visible/reachable where required.
- Seal the joint cleanly per project specs.
- Avoid screw tips projecting into problem areas when avoidable.
- Check that flex/round connection can land without stress.
Say this to your foreman
Do you want this spin-in damper handle facing the access side, and is this location approved before I cut the main?
More in QA/QC, Punchlist, Documentation & Turnover