The branch is supported, but after connection the riser fitting rotated and the main is no longer plumb. I checked the branch hanger and connection. Do you want the branch support or fitting position corrected first?
Watch out
Do not pull the branch into place with the joint hardware or use the riser connection as the branch support.
Check
Measure the riser and branch alignment before and after the connection.
Inspect the branch support location and fitting deformation.
Check connector engagement and reinforcement.
Verify the approved correction before adding or moving supports.
Steps
Measure the riser and branch alignment before and after the connection.
Inspect the branch support location and fitting deformation.
Check connector engagement and reinforcement.
Verify the approved correction before adding or moving supports.
Say this to your foreman
The branch is supported, but after connection the riser fitting rotated and the main is no longer plumb. I checked the branch hanger and connection. Do you want the branch support or fitting position corrected first?