Trapeze rods bend out of plumb to catch a 45-degree fitting
Threaded rods are meant to hang straight. If they are bent sideways to reach an angled fitting, relocate the anchors or support layout so the rods carry load vertically.
Do not bend threaded rod to reach an angled fitting or out-of-position trapeze.
Check
Sight down both rods and check plumb.
Look for rods bent to reach the strut bar.
Check anchor locations against the lower support points.
Relocate anchors if needed so rods hang straight.
Re-level the trapeze after moving supports.
Steps
Sight down both rods and check plumb.
Look for rods bent to reach the strut bar.
Check anchor locations against the lower support points.
Relocate anchors if needed so rods hang straight.
Re-level the trapeze after moving supports.
Say this to your foreman
The rods on this angled run are bent out of plumb to reach the trapeze. I think the deck anchors need to move over the true support points. Do you want me to reset the hanger layout?