Transition Slope Limits

What slope does the design want on this transition?

I'm checking transition slope limits at [location]. I found Too-steep transition adds pressure drop/noise. What slope does the design want on this transition?

Cutting, Holes, Penetrations & Field Fab 2nd Year YELLOW

Stop if

Hold point on transition slope limits: I have the location, photo, drawing/detail/spec section, and what I checked. Who should verify before this gets cut, drilled, sealed, supported, connected, controlled, or covered?

Watch out

Guess an angle that 'looks fine'

Check

room/grid/area
photo of condition
drawing/detail/spec/submittal
what I already checked
what is blocking progress

Say this to your foreman

14583 transition slope limits fittings & transitions yellow 2 what slope does the design want on this transition? i'm checking transition slope limits at [location]. i found too-steep transition adds pressure drop/noise. what slope does the design want on this transition? transition transition, slope, taper angle

More in Cutting, Holes, Penetrations & Field Fab