Temporary Test Caps And Plugs

What temporary cap method do you want for these openings during the leakage test, and who verifies removal after?

I'm checking temporary test caps and plugs at [location]. I found: Tape-only caps peel off, test plugs get put in the wrong place, or open collars get missed.. What temporary cap method do you want for these openings during the leakage test, and who verifies removal after?

Sealing, Leakage, Mastic & Pressure Testing 2nd Year YELLOW

Stop if

Hold point on temporary test caps and plugs: I have the location, photo, drawing/detail/spec/submittal, and what I checked. Who should verify before this gets covered, tested, started, labeled, or turned over?

Watch out

Do not rely on loose tape for pressure. Do not screw into listed damper frames or rated assemblies without direction. Do not forget to remove temporary caps after testing.

Check

room/grid/area
photo of condition
drawing/detail/spec/submittal
what I already checked
what is blocking progress

Say this to your foreman

14616 temporary test caps and plugs sealing, mastic, tape & leakage testing yellow 2nd what temporary cap method do you want for these openings during the leakage test, and who verifies removal after? temporary duct cap, test plug, pressure test cap, cap branch for leak test tape-only caps peel off, test plugs get put in the wrong place, or open collars get missed.

More in Sealing, Leakage, Mastic & Pressure Testing