TAB Readiness Walk

Before TAB, can we walk this zone for access, damper handles, labels, test ports, and open punch items?

I'm checking tab readiness walk at [location]. I found: TAB shows up and cannot reach dampers or verify system setup.. Before TAB, can we walk this zone for access, damper handles, labels, test ports, and open punch items?

Airflow, Noise, Vibration & TAB 2nd Year YELLOW

Stop if

Hold point on tab readiness walk: I have the location, photo, drawing/detail/spec/submittal, and what I checked. Who should verify before this gets covered, tested, started, labeled, or turned over?

Watch out

Do not call an area ready for TAB if dampers are buried or equipment access is blocked.

Check

room/grid/area
photo of condition
drawing/detail/spec/submittal
what I already checked
what is blocking progress

Say this to your foreman

14620 tab readiness walk airflow, noise, vibration & tab impacts yellow 2nd before tab, can we walk this zone for access, damper handles, labels, test ports, and open punch items? tab ready, balance walk, air balance prep, damper access, test ports tab shows up and cannot reach dampers or verify system setup.