Structural drawing/approved insert location not checked

Do not move seismic/sway bracing casually: not checking structural drawing/approved insert location.

High-risk starter answer - stop before you change, move, drill, or attach anything tied to seismic bracing, sway control, structural support, crane work, or rigging. Verify the approved detail and the qualified person's direction before acting. Treat the condition as project-specific until the foreman verifies what the approved drawing/detail requires.

Seismic Bracing & Structural Coordination 4th Year RED

Stop if

Ask whenever brace location, anchor, angle, attachment, or clearance changes.

Watch out

Do not modify or copy bracing/rigging from another area just because it looks similar.

Check

Identify whether you are looking at a hanger, brace, restraint, anchor, insert, structural member, rigging gear, or crane/lift-day zone.

Steps

Identify whether it is a hanger, brace, restraint, or structural attachment.
Check seismic/coordination drawing if available.
Photograph full load path from duct to structure.
Focus on the actual issue: not checking structural drawing/approved insert location.
Photograph or mark the condition if someone else needs to approve it.

Say this to your foreman

In Seismic Bracing, Sway Control & Structural Coordination, I'm looking at: Structural drawing/approved insert location not checked. What should I verify before I cut, drill, seal, cover, move, or install?

More in Seismic Bracing & Structural Coordination