Spin-In / Tap Final Check Near Diffuser

Do you want this spin-in damper handle facing the access side, and is this location approved before I cut the main?

I'm checking finish work for spin-in / tap final check near diffuser. I have the room/grid, photo, tag, and measurement ready. Do you want this spin-in damper handle facing the access side, and is this location approved before I cut the main?

Stop if

• Finish work red-zone check: Spin-In / Tap Final Check Near Diffuser. I have location, photos, drawings/details, and the access/inspection concern ready. Who verifies before this gets covered or turned over?

Watch out

• Stop before cutting a main if the tap location, size, airflow direction, or damper access is not confirmed.

Check

• room/grid/area
• photo wide and close
• device tag or drawing note
• measurement/control point
• access/inspection concern

More in Apprentice Workflow, Communication & Learning