Screw Pattern and Clean Grille Install

Do we have the correct finish screws for these grilles, or should I wait instead of using mixed hardware?

I'm checking finish work for screw pattern and clean grille install. I have the room/grid, photo, tag, and measurement ready. Do we have the correct finish screws for these grilles, or should I wait instead of using mixed hardware?

Stop if

• Finish work red-zone check: Screw Pattern and Clean Grille Install. I have location, photos, drawings/details, and the access/inspection concern ready. Who verifies before this gets covered or turned over?

Watch out

• Stop if the backing is missing, the grille will warp, or the hardware does not match the approved finish.

Check

• room/grid/area
• photo wide and close
• device tag or drawing note
• measurement/control point
• access/inspection concern

More in Apprentice Workflow, Communication & Learning