Round-To-Rectangular Transitions

How does this square-to-round orient on the print?

I'm checking round-to-rectangular transitions at [location]. I found Wrong orientation, poor fit, added loss. How does this square-to-round orient on the print?

Cutting, Holes, Penetrations & Field Fab 2nd Year BLUE

Stop if

Hold point on round-to-rectangular transitions: I have the location, photo, drawing/detail/spec section, and what I checked. Who should verify before this gets cut, drilled, sealed, supported, connected, controlled, or covered?

Watch out

Assume symmetric

Check

room/grid/area
photo of condition
drawing/detail/spec/submittal
what I already checked
what is blocking progress

Say this to your foreman

14591 round-to-rectangular transitions fittings & transitions blue 2 how does this square-to-round orient on the print? i'm checking round-to-rectangular transitions at [location]. i found wrong orientation, poor fit, added loss. how does this square-to-round orient on the print? square to round square to round, transition, rect-to-round

More in Cutting, Holes, Penetrations & Field Fab