Tell someone or document it before you close it up.
Riser Joint Cannot Be Completed With Shaft Wall Framing Installed
Coordinate the duct-install sequence with shaft-wall framing and close-in before the framing blocks joint access, support installation, damper access, or inspection.
The shaft-wall framing now blocks the backside of the next riser joint. I checked access from both floors and cannot complete the hardware. Can we coordinate the approved framing and duct sequence before continuing?
Watch out
Do not remove rated framing, cut studs, or close an incomplete joint behind the wall.
Check
Identify what framing is temporary and what is part of the rated assembly.
Check the remaining access to all joint sides and supports.
Verify required inspections before close-in.
Coordinate the approved sequence with the framing trade and superintendent.
Steps
Identify what framing is temporary and what is part of the rated assembly.
Check the remaining access to all joint sides and supports.
Verify required inspections before close-in.
Coordinate the approved sequence with the framing trade and superintendent.
Say this to your foreman
The shaft-wall framing now blocks the backside of the next riser joint. I checked access from both floors and cannot complete the hardware. Can we coordinate the approved framing and duct sequence before continuing?