Report a seismic brace you moved

I moved/loosened this brace and I am not sure it went back to the approved angle. Can you verify it before we continue?

I need to report this clean: I moved/loosened this brace at [location] and I am not sure it went back to the approved angle/detail. I stopped work and took photos. Can you verify it before anything gets covered or loaded?

Watch out

• Do not keep working while the red-zone condition is unresolved.

Check

• room/grid/area
• wide photo
• close photo
• drawing/submittal/detail if available
• what decision is needed

More in Seismic Bracing & Structural Coordination