Rectangular Reducers And Increasers

Which sides taper on this reducer per the drawing?

I'm checking rectangular reducers and increasers at [location]. I found Reducing on the wrong side hits equipment/coordination. Which sides taper on this reducer per the drawing?

Cutting, Holes, Penetrations & Field Fab 2nd Year BLUE

Stop if

Hold point on rectangular reducers and increasers: I have the location, photo, drawing/detail/spec section, and what I checked. Who should verify before this gets cut, drilled, sealed, supported, connected, controlled, or covered?

Watch out

Guess taper sides

Check

room/grid/area
photo of condition
drawing/detail/spec/submittal
what I already checked
what is blocking progress

Say this to your foreman

14588 rectangular reducers and increasers fittings & transitions blue 2 which sides taper on this reducer per the drawing? i'm checking rectangular reducers and increasers at [location]. i found reducing on the wrong side hits equipment/coordination. which sides taper on this reducer per the drawing? reducer reducer, increaser, side taper, bottom taper

More in Cutting, Holes, Penetrations & Field Fab