Offset measurement basics

The offset is over length. Do you want an offset fitting or route change?

I'm checking offset measurement basics. I measured the field condition and want to verify the reference point before I act. The offset is over length. Do you want an offset fitting or route change?

Apprentice Workflow, Communication & Learning 2nd Year YELLOW

Stop if

Measurement question: Offset measurement basics. I have the location, photo, and measured reference point ready. Who should verify before this becomes cut, ordered, drilled, or covered?

Watch out

Do not eyeball an offset in the air.

Check

room/grid/area
photo with tape visible
reference point
measured number
drawing/detail if available

Say this to your foreman

9012 offset measurement basics field measuring yellow 2 the offset is over length. do you want an offset fitting or route change? i'm checking offset measurement basics. i measured the field condition and want to verify the reference point before i act. the offset is over length. do you want an offset fitting or route change? measurement question: offset measurement basics. i have the location, photo, and measured reference point ready. who should verify before this becomes cut, ordered, drilled, or covered?

More in Apprentice Workflow, Communication & Learning