Nuts Washers and Locking Hardware on Hangers
Install the specified nut, washer, jam nut, lock nut, or other locking method in the correct order and fully engage the threads without damaging the rod.
Stop if This hanger detail shows [hardware]. Do you want jam nuts, lock nuts, or another locking method here, and how much thread should remain exposed? Watch out Do not substitute random hardware, mix thread sizes, leave loose single nuts, or use damaged threads on an overhead support. Check Match hardware size and thread to the rod or bolt Confirm washer type and locking method from the detail Check full bearing on strut, angle, clamp, or bracket Leave adequate thread engagement without hazardous excess Final-tighten and inspect after the run is aligned and loaded Steps Match hardware size and thread to the rod or bolt Confirm washer type and locking method from the detail Check full bearing on strut, angle, clamp, or bracket Leave adequate thread engagement without hazardous excess Final-tighten and inspect after the run is aligned and loaded Say this to your foreman This hanger detail shows [hardware]. Do you want jam nuts, lock nuts, or another locking method here, and how much thread should remain exposed?
Copy this More in Hangers, Supports, Rods & Trapeze