Missing offset travel when laying out offsets | TinnerFlow

Field problem

Verify first

Verify before you commit. Cheap to catch now.

Missing offset travel when laying out offsets

For rectangular/square offset layout, use the O.W.L. check: Offset × Width ÷ Length, then verify the real space before cutting.

Print Reading, Tags & Layout 2nd Year YELLOW

Watch out

Do not lay out an offset by guessing the angle or copying another offset from a different condition.

Check

Measure the offset amount.
Measure the width/layout width.
Measure available length/run.
Use the O.W.L. calculator if needed.
Check that the fitting can actually fit the ceiling space.

Steps

Measure the offset amount.
Measure the width/layout width.
Measure available length/run.
Use the O.W.L. calculator if needed.
Check that the fitting can actually fit the ceiling space.

Say this to your foreman

This offset needs to move this far in this length. Do you want me to run the O.W.L. calculation before cutting?

More in Print Reading, Tags & Layout