Tell someone or document it before you close it up.
Long Duct Cannot Turn From the Stockroom Into the Sales Floor
Recheck the full material path and installation sequence before cutting the section. The solution may be a shorter approved assembly, different entry path, changed staging order, or a shop split-not an improvised field cut.
This section fits the final run, but it cannot make the stockroom turn with the cases and door frame in place. I measured the choke point and checked the alternate path. Do you want the section split by the shop or the install sequence changed?
Watch out
Do not cut a finished long section in the doorway without confirming the new joint and connector plan.
Check
Measure doorway width, height, diagonal clearance, corridor turns, ceiling changes, and final rotation space.
Check whether cases, racks, doors, or temporary barriers changed after planning.
Verify whether the section can enter before other work or fixtures are installed.
Document the limiting point and the section piece marks.
Steps
Measure doorway width, height, diagonal clearance, corridor turns, ceiling changes, and final rotation space.
Check whether cases, racks, doors, or temporary barriers changed after planning.
Verify whether the section can enter before other work or fixtures are installed.
Document the limiting point and the section piece marks.
Say this to your foreman
This section fits the final run, but it cannot make the stockroom turn with the cases and door frame in place. I measured the choke point and checked the alternate path. Do you want the section split by the shop or the install sequence changed?