Laboratory Biosafety Cabinet Exhaust Coordination

This serves a biosafety cabinet/lab exhaust. Do we need a dedicated detail, material, and TAB/certification hold point?

I'm checking laboratory biosafety cabinet exhaust coordination at [location]. I found: Exhaust connection, slope, access, or fan tie-in is treated like normal duct.. This serves a biosafety cabinet/lab exhaust. Do we need a dedicated detail, material, and TAB/certification hold point?

Grease Duct, Kitchen & Industrial Exhaust 3rd Year RED

Stop if

Hold point on laboratory biosafety cabinet exhaust coordination: I have the location, photo, drawing/detail/spec/submittal, and what I checked. Who should verify before this gets covered, tested, started, labeled, rerouted, or turned over?

Watch out

Do not connect, cap, or reroute lab exhaust without approved detail and lab controls direction.

Check

room/grid/area
photo of condition
current drawing/detail/spec/submittal
what I already checked
what decision is needed

Say this to your foreman

14708 laboratory biosafety cabinet exhaust coordination grease duct, kitchen exhaust & industrial exhaust red 3 this serves a biosafety cabinet/lab exhaust. do we need a dedicated detail, material, and tab/certification hold point? biosafety cabinet exhaust, lab exhaust duct, bsc duct, lab hood connection exhaust connection, slope, access, or fan tie-in is treated like normal duct.

More in Grease Duct, Kitchen & Industrial Exhaust