How do I properly secure the reheat coil to the VAV discharge?

Line up the slip flanges or raw edges carefully. Drive sheet metal screws (tek screws) through the mating flanges spaced every 4 to 6 inches, and use high-temperature foil tape or silicone sealant to seal the perimeter completely. Take care not to puncture the internal hydronic circuit or electric element racks with long screws.

['Line up the slip flanges or raw edges carefully. Drive sheet metal screws (tek screws) through the mating flanges spaced every 4 to 6 inches, and use high-temperature foil tape or silicone sealant to seal the perimeter completely. Take care not to puncture the internal hydronic circuit or electric element racks with long screws.', '--']

Equipment Connections: RTU, AHU, VAV, Fans & Louvers 2nd Year YELLOW

Stop if

Use this as training guidance. The foreman, approved drawings, project specs, manufacturer installation instructions, employer safety policy, and AHJ/code requirements always control the final answer.

Steps

Line up the slip flanges or raw edges carefully. Drive sheet metal screws (tek screws) through the mating flanges spaced every 4 to 6 inches, and use high-temperature foil tape or...

Say this to your foreman

how do i properly secure the reheat coil to the vav discharge?

More in Equipment Connections: RTU, AHU, VAV, Fans & Louvers