How do I hang spiral duct using cable hangers (Gripple) instead of strap?

1. Wrap the looped wire cable around the structural steel or deck anchor overhead. 2. Loop the cable around the spiral pipe or through a specialized teardrop ring clamp. 3. Feed the raw wire end through the one-way Gripple locking mechanism block, pulling it tight until the pipe is elevated to the exact elevation line.

['1. Wrap the looped wire cable around the structural steel or deck anchor overhead. 2. Loop the cable around the spiral pipe or through a specialized teardrop ring clamp. 3. Feed the raw wire end through the one-way Gripple locking mechanism block, pulling it tight until the pipe is elevated to the exact elevation line.']

Stop if

• Use this as training guidance. The foreman, approved drawings, project specs, manufacturer installation instructions, employer safety policy, and AHJ/code requirements always control the final answer.

Steps

• Wrap the looped wire cable around the structural steel or deck anchor overhead.
• Loop the cable around the spiral pipe or through a specialized teardrop ring clamp.
• Feed the raw wire end through the one-way Gripple locking mechanism block, pulling it tight until the pipe is elevated to the exact elevation line.

More in Hangers, Supports, Rods & Trapeze