How do I cut a spin-in collar into a piece of round spiral duct?

1. Place the spin-in collar flat against the spiral pipe and trace around the inside diameter with a marker. 2. Drill a pilot starter hole inside your marked line. 3. Use a pair of red or green aviation snips to cut out the circle cleanly, staying exactly on the line. 4. Insert the spin-in collar flange into the hole, press it firmly down until the mechanical tabs lock, and secure the perimeter flange using short tek screws before sealing with mastic.

['1. Place the spin-in collar flat against the spiral pipe and trace around the inside diameter with a marker. 2. Drill a pilot starter hole inside your marked line. 3. Use a pair of red or green aviation snips to cut out the circle cleanly, staying exactly on the line. 4. Insert the spin-in collar flange into the hole, press it firmly down until the mechanical tabs lock, and secure the perimeter flange using short tek screws before sealing with mastic.']

Stop if

• Use this as training guidance. The foreman, approved drawings, project specs, manufacturer installation instructions, employer safety policy, and AHJ/code requirements always control the final answer.

Steps

• Place the spin-in collar flat against the spiral pipe and trace around the inside diameter with a marker.
• Drill a pilot starter hole inside your marked line.
• Use a pair of red or green aviation snips to cut out the circle cleanly, staying exactly on the line.
• Insert the spin-in collar flange into the hole, press it firmly down until the mechanical tabs lock, and secure the perimeter flange using short tek screws before sealing with mastic.

More in Flex Duct, Boots, Collars & Grilles