Hangers with a straight run not aligned

Treat supports as load-path work: not aligning hangers with a straight run.

Treat hangers and supports as load-path work. Verify the support detail, substrate, elevation, and clearance before loading duct.

Hangers, Supports, Rods & Trapeze 2nd Year YELLOW

Stop if

Ask before moving anchors, changing spacing, deleting supports, drilling structure, or altering trapeze/seismic layout.

Watch out

Do not hang permanent duct from temporary wire, unapproved anchors, another trade's support, or sharp contact points.

Check

Confirm support type, substrate, elevation, insulation allowance, and conflicts
Support duct before stressing joints
Document conflicts before cover

Steps

Identify the support type and duct being carried.
Check approved detail or foreman direction.
Verify anchor/hardware and attachment point.
Focus on the actual issue: not aligning hangers with a straight run.
Photograph or mark the condition if someone else needs to approve it.

Say this to your foreman

In Hanger Systems, Rods, Straps, Trapeze & Anchors, I'm looking at: Hangers with a straight run not aligned. What should I verify before I cut, drill, seal, cover, move, or install?

More in Hangers, Supports, Rods & Trapeze