Hanger/brace correction not signed off
Check supports before final sign-off: correct type, secure anchors, no missing rods/straps, no sag, and no other trade loading them.
Stop if
- Can you verify these supports before this run is signed off?
Watch out
- Do not call duct complete when it is hanging on temporary or questionable support.
Check
- Look at every support in the run.
- Check rods/straps/trapeze/anchors are complete.
- Look for sag, twist, missing nuts, loose hardware, or damaged supports.
- Make sure no other trade is hanging from the duct/support.
- Ask before adjusting support spacing/type.
Steps
- Look at every support in the run.
- Check rods/straps/trapeze/anchors are complete.
- Look for sag, twist, missing nuts, loose hardware, or damaged supports.
- Make sure no other trade is hanging from the duct/support.
- Ask before adjusting support spacing/type.
Say this to your foreman
Can you verify these supports before this run is signed off?
More in QA/QC, Punchlist, Documentation & Turnover