Flex Final Connection to Diffuser Box

This flex route is tight and may kink near the diffuser. Do you want a hard elbow, box move, shorter route, or different support?

I'm checking finish work for flex final connection to diffuser box. I have the room/grid, photo, tag, and measurement ready. This flex route is tight and may kink near the diffuser. Do you want a hard elbow, box move, shorter route, or different support?

Stop if

• Finish work red-zone check: Flex Final Connection to Diffuser Box. I have location, photos, drawings/details, and the access/inspection concern ready. Who verifies before this gets covered or turned over?

Watch out

• Stop if the flex is crushed, unsupported, too tight to service, or routed through another trade's access/clearance zone.

Check

• room/grid/area
• photo wide and close
• device tag or drawing note
• measurement/control point
• access/inspection concern

More in Apprentice Workflow, Communication & Learning