Flex Bend Radius And Kinks

Am I keeping enough bend radius on this flex turn?

I'm checking flex bend radius and kinks at [location]. I found Kinked flex chokes airflow; tight radius at boot. Am I keeping enough bend radius on this flex turn?

Flex Duct, Boots, Collars & Grilles 1st Year YELLOW

Stop if

Hold point on flex bend radius and kinks: I have the location, photo, drawing/detail/spec section, and what I checked. Who should verify before this gets cut, drilled, sealed, supported, connected, controlled, or covered?

Watch out

Zip-tie flex into a hard bend

Check

room/grid/area
photo of condition
drawing/detail/spec/submittal
what I already checked
what is blocking progress

Say this to your foreman

14608 flex bend radius and kinks flex duct yellow 1 am i keeping enough bend radius on this flex turn? i'm checking flex bend radius and kinks at [location]. i found kinked flex chokes airflow; tight radius at boot. am i keeping enough bend radius on this flex turn? flex kink flex bend radius, kink, sharp turn

More in Flex Duct, Boots, Collars & Grilles