Field-Verify Throat, Heel, Centerline, Rise, and Run Before Releasing a Fitting

I sketched this offset looking downstream, marked top, and labeled throat, heel, rise, run, and both connector ends. Can you check the field release before I send it to the shop?

Measuring, Field Verification & Layout Marks 2nd Year GREEN

Watch out

Do not send a list of unlabeled dimensions or mix inside, outside, throat, heel, and centerline measurements on one sketch.

Check

current shop drawing or spool
piece mark and connector ends
photo of fitting and install space
verified dimensions and viewing direction
what has already been checked

Say this to your foreman

field-verify throat, heel, centerline, rise, and run before releasing a fitting fitting orientation & field verification field measure fitting throat heel centerline rise run shop sketch offset dimensions record the fitting from clear control points and identify exactly which dimension is throat, heel, centerline, rise, run, and straight length. the shop should not have to guess how your field numbers relate to the fitting. i sketched this offset looking downstream, marked top, and labeled throat, heel, rise, run, and both connector ends. can you check the field release before i send it to the shop?

More in Measuring, Field Verification & Layout Marks