Field-measure duct run length

Do you want this measured joint-to-joint, flange-to-flange, or finished installed length?

I'm checking field-measure duct run length. I measured the field condition and want to verify the reference point before I act. Do you want this measured joint-to-joint, flange-to-flange, or finished installed length?

Apprentice Workflow, Communication & Learning 2nd Year YELLOW

Stop if

Measurement question: Field-measure duct run length. I have the location, photo, and measured reference point ready. Who should verify before this becomes cut, ordered, drilled, or covered?

Watch out

Do not hand in a run length without saying what faces you measured from.

Check

room/grid/area
photo with tape visible
reference point
measured number
drawing/detail if available

Say this to your foreman

9009 field-measure duct run length field measuring yellow 2 do you want this measured joint-to-joint, flange-to-flange, or finished installed length? i'm checking field-measure duct run length. i measured the field condition and want to verify the reference point before i act. do you want this measured joint-to-joint, flange-to-flange, or finished installed length? measurement question: field-measure duct run length. i have the location, photo, and measured reference point ready. who should verify before this becomes cut, ordered, drilled, or covered?

More in Apprentice Workflow, Communication & Learning