Coordinate Duct Sensor Locations Before Drilling
Confirm the exact sensor type, orientation, insertion depth, access, straight-run needs, and controls detail before cutting the duct.
Stop if
- Controls shows a [sensor type] here. Is this the approved mounting side and distance from the fitting, and who owns the penetration and patch?
Watch out
- Do not drill from a vague plan symbol or put the sensor where it cannot be removed after ceilings close.
Check
- Identify the sensor from the controls submittal
- Verify location against fittings, dampers, coils, fans, and access doors
- Confirm mounting side and future service access
- Protect liner, insulation, and vapor barrier details
- Coordinate who drills, installs, wires, labels, and seals the opening
Steps
- Identify the sensor from the controls submittal
- Verify location against fittings, dampers, coils, fans, and access doors
- Confirm mounting side and future service access
- Protect liner, insulation, and vapor barrier details
- Coordinate who drills, installs, wires, labels, and seals the opening
Say this to your foreman
Controls shows a [sensor type] here. Is this the approved mounting side and distance from the fitting, and who owns the penetration and patch?
More in Coordination, Clashes, Sequencing & Rework