Ceiling Grid and T-Bar Awareness

Is this grid layout final, and should I set this air device by the RCP, the tile center, or the foreman layout marks?

I'm checking finish work for ceiling grid and t-bar awareness. I have the room/grid, photo, tag, and measurement ready. Is this grid layout final, and should I set this air device by the RCP, the tile center, or the foreman layout marks?

Stop if

• Finish work red-zone check: Ceiling Grid and T-Bar Awareness. I have location, photos, drawings/details, and the access/inspection concern ready. Who verifies before this gets covered or turned over?

Watch out

• Stop if the grid is not final, a ceiling conflict exists, or the device would block access to another trade's required component.

Check

• room/grid/area
• photo wide and close
• device tag or drawing note
• measurement/control point
• access/inspection concern

More in Apprentice Workflow, Communication & Learning