Balancing Port Location And Plugs

Where does TAB want the test port, and what plug/label do we use after the reading?

I'm checking balancing port location and plugs at [location]. I found: Holes are drilled in bad locations, left open, or covered by insulation without plugs.. Where does TAB want the test port, and what plug/label do we use after the reading?

Airflow, Noise, Vibration & TAB 2nd Year YELLOW

Stop if

Hold point on balancing port location and plugs: I have the location, photo, drawing/detail/spec/submittal, and what I checked. Who should verify before this gets covered, tested, started, labeled, or turned over?

Watch out

Do not randomly drill test holes. Do not leave open holes. Do not cover ports before TAB is done.

Check

room/grid/area
photo of condition
drawing/detail/spec/submittal
what I already checked
what is blocking progress

Say this to your foreman

14619 balancing port location and plugs airflow, noise, vibration & tab impacts yellow 2nd where does tab want the test port, and what plug/label do we use after the reading? test port, static pressure hole, pitot hole, tab plug, pressure tap holes are drilled in bad locations, left open, or covered by insulation without plugs.