Do not force fittings to compensate for a crooked spiral cut.
Check
Check the cut face against a wrap template or square reference.
Look for one side of the pipe seating deeper than the other.
Trim the end square with the approved cutting tool.
Deburr the edge before joining.
Recheck laser/string line before continuing downstream.
Steps
Check the cut face against a wrap template or square reference.
Look for one side of the pipe seating deeper than the other.
Trim the end square with the approved cutting tool.
Deburr the edge before joining.
Recheck laser/string line before continuing downstream.
Say this to your foreman
The spiral run at [location] is walking off the laser because the last cut is out of square. I marked a clean wrap line. Do you want me to trim it square before adding the next joint?