Apprentice answer

What's the best way to modify a square-to-round transition if the VAV is off-center

2nd YearVAVs, Fan Coils & Equipment ConnectionsCheck first

If the layout has shifted, you can field-modify the transition by trimming back the length of the flat rectangular sheet metal wrapper sides on one axis. * This skews the round collar center point over toward the path of the new VAV alignment line. If the shift is massive, stop and have the shop burn a new asymmetric fitting on the plasma table to avoid choking down the air stream.

Ask a jobsite question Back to VAVs, Fan Coils & Equipment Connections

Plain-English answer

Field checklist

If the layout has shifted, you can field-modify the transition by trimming back the length of the flat rectangular sheet metal wrapper sides on one axis. * This skews the round collar...

Ask Foreman

Hey boss, I’m checking field mods: What's the best way to modify a square-to-round transition if the VAV is off-center? I found the likely issue and want to verify the next step before I lock it in. Do you want me to adjust it now or check the drawing/detail first?

Verify before acting

Use this as training guidance. The foreman, approved drawings, project specs, manufacturer installation instructions, employer safety policy, and AHJ/code requirements always control the final answer.

Related questions in this category

How do I read the equipment schedule to know which VAV goes in which room?2nd Year Do I need to internally line the first 10 feet of duct leaving the VAV box?2nd Year How do I install a flexible connection (canvas connector) at the equipment discharge?2nd Year Where do the auxiliary drain pans go under a fan coil unit?2nd Year What's the best way to support a heavy fan coil unit above a drop ceiling?2nd Year How many duct diameters of straight pipe do I need before the inlet of a VAV box?2nd Year