Apprentice answer

How do I support a massive 90-degree elbow so it doesn't sag on the heel

1st YearHangers, Supports & AnchorsCheck first

Install a dedicated trapeze hanger immediately before the throat of the elbow and another hanger support structure catching the center-line or heel of the turn. Never let a heavy fitting dangle off a straight run without dedicated local support.

Ask a jobsite question Back to Hangers, Supports & Anchors

Plain-English answer

Field checklist

Install a dedicated trapeze hanger immediately before the throat of the elbow and another hanger support structure catching the center-line or heel of the turn. Never let a heavy...

Ask Foreman

Hey boss, I’m checking hangers & supports: How do I support a massive 90-degree elbow so it doesn't sag on the heel? I found the likely issue and want to verify the next step before I lock it in. Do you want me to adjust it now or check the drawing/detail first?

Verify before acting

Use this as training guidance. The foreman, approved drawings, project specs, manufacturer installation instructions, employer safety policy, and AHJ/code requirements always control the final answer.

Related questions in this category

What's the rule of thumb for how far the all-thread should stick out below the unistrut nut?1st Year When do I need to use isolation pads on my duct hangers?1st Year How do I square up my hanger points off a structural I-beam?1st Year How do I hang spiral duct using cable hangers (Gripple) instead of strap?1st Year When building a unistrut trapeze, should the strut open face point up or down?1st Year What's the proper gauge of hanger strap for medium-pressure ductwork?1st Year