TinnerFlow™2nd YearMeasuring & LayoutYELLOW · Check First
Do not rack the joints or dog-leg the duct to hide the layout miss. Measure the offset, confirm the target point, and decide whether the correction is a new tap, patch/remake, or approved offset fitting.
A branch tap that is off by a few inches turns into ugly duct fast if you try to force the run straight with crooked joints. The first move is to stop and measure the real offset from the main to the sleeve, diffuser, or wall opening.
Likely recovery paths include correcting the tap location, patching/remaking the affected main section, or building an approved short offset/transition if the run can still meet access, seal, and airflow requirements.
Use this as training guidance. The foreman, approved drawings, project specs, manufacturer installation instructions, employer safety policy, and AHJ/code requirements always control the final answer.