TinnerFlow logoTinnerFlow™
Mistake & recovery · #017

Using a dull blade or bit and applying excessive force to compensate

1st YearTools & Equipment

Replace blades and bits proactively. Dull cutting tools require dangerous force, produce poor cuts, and burn out motors. Cost of a new bit is nothing comp…

Search Field RescueAsk ForemanOpen in mistake guide

Safer field move

Replace blades and bits proactively. Dull cutting tools require dangerous force, produce poor cuts, and burn out motors. Cost of a new bit is nothing compared to a ruined piece or an injury.

Ask Foreman

Can you verify this before I keep going? I’m looking at: Using a dull blade or bit and applying excessive force to compensate. What’s the approved correction for this job?

Do not

Do not hide, force, cover, or “make it work” if this affects safety, access, airflow, rated assemblies, supports, equipment, or inspection. Stop and verify the approved correction.

Related mistakes

#020 · Using the wrong drill bit material for the substrate (e.g., wood bit on metal)1st Year · Tools & Equipment#062 · Running a plasma cutter without checking consumables, ruining a large sheet2nd Year · Tools & Equipment#016 · Not checking that tools are in good working condition before use1st Year · Tools & Equipment#019 · Not returning borrowed tools to the tool crib or journeyman1st Year · Tools & Equipment#018 · Leaving tools on top of ladders or elevated surfaces where they can fall1st Year · Tools & Equipment

Related apprentice questions

#070 · How do I keep my flex duct cuts clean without tearing the inner core?2nd Year · Flex Duct & Grilles#001 · What's the difference between red, green, and yellow aviation snips?1st Year · Hand Tools & Safety#152 · How do I calculate the center of gravity for an asymmetrical Make-Up Air Unit (MAU)?4th Year · Rigging & Equipment#109 · How do I coordinate with the roofer before cutting the roof deck for a new curb?3rd Year · Roof Work & Curbs