Rectangular duct S-and-drive

Before you start

• Check the end construction on both sections.
• S-and-drive only works if both p...
• Stage the needed tools and materials before lifting the section: S-cleats, drive cleats, hand seamer, hammer, duct stretcher if you have one, ....

Lay it out

1. Slide the S-cleats onto the top and bottom edges of one section. They shou...

Set and support it

1. Set and verify the approved supports before the connection is closed. Keep the joint from carrying the weight of the duct or fitting.
2. Use the approved support method for this condition: Hanger strap, trapeze or rod/strut.

Make the connection

1. 1

   Slide the S-cleats onto the top and bottom edges of one section. They shou...